Cisco GS7000 Manuale di istruzioni per l'installazione - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Hardware di rete Cisco GS7000. Cisco GS7000 13. Gainmaker node
forward local injection module
Anche per Cisco GS7000: Manuale di manutenzione (15 pagine), Risoluzione dei problemi (4 pagine), Manuale di risoluzione dei problemi (12 pagine)
Stampa la pagina
Loosen the screws securing the module.
3
4
Lift the module straight up out of the housing to unplug it.
Note: Pull up on the built-in handle.
To install a module, position it in the desired location and carefully slide the
5
module into its slot until connected to the optical interface board.
Tighten the screws securing the module. Torque screws from 25 to 30 in-lbs (2.8
6
to 3.4 Nm).
7
Carefully reconnect any optical fibers that were removed from the original
module.
Important: Clean optical connectors before reconnecting. Follow recommended
fiber optic cleaning procedures.
8
Close the node housing. Refer to Closing the Housing for complete instructions.
4019330 Rev C
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
FLI Module Installation
9