Cisco GS7000 Panduan Petunjuk Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Perangkat Keras Jaringan Cisco GS7000. Cisco GS7000 13 halaman. Gainmaker node forward local injection module
Juga untuk Cisco GS7000: Panduan Pemeliharaan (15 halaman), Pemecahan masalah (4 halaman), Panduan Pemecahan Masalah (12 halaman)

Halaman Cetak
Cisco GS7000 Panduan Petunjuk Instalasi
Loosen the screws securing the module.
3
4
Lift the module straight up out of the housing to unplug it.
Note: Pull up on the built-in handle.
To install a module, position it in the desired location and carefully slide the
5
module into its slot until connected to the optical interface board.
Tighten the screws securing the module. Torque screws from 25 to 30 in-lbs (2.8
6
to 3.4 Nm).
7
Carefully reconnect any optical fibers that were removed from the original
module.
Important: Clean optical connectors before reconnecting. Follow recommended
fiber optic cleaning procedures.
8
Close the node housing. Refer to Closing the Housing for complete instructions.
4019330 Rev C
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
FLI Module Installation
9