Cisco GS7000 Handleiding voor installatie-instructies - Pagina 9
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Cisco GS7000. Cisco GS7000 13 pagina's. Gainmaker node
forward local injection module
Ook voor Cisco GS7000: Onderhoudshandleiding (15 pagina's), Problemen oplossen (4 pagina's), Handleiding voor probleemoplossing (12 pagina's)
Pagina afdrukken
Loosen the screws securing the module.
3
4
Lift the module straight up out of the housing to unplug it.
Note: Pull up on the built-in handle.
To install a module, position it in the desired location and carefully slide the
5
module into its slot until connected to the optical interface board.
Tighten the screws securing the module. Torque screws from 25 to 30 in-lbs (2.8
6
to 3.4 Nm).
7
Carefully reconnect any optical fibers that were removed from the original
module.
Important: Clean optical connectors before reconnecting. Follow recommended
fiber optic cleaning procedures.
8
Close the node housing. Refer to Closing the Housing for complete instructions.
4019330 Rev C
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
FLI Module Installation
9