Cisco TelePresence Server 7010 Come iniziare - Pagina 8
Sfoglia online o scarica il pdf Come iniziare per Hardware di rete Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 16. 600w ac-input power supply and fan tray replacement
Anche per Cisco TelePresence Server 7010: Manuale di istruzioni per la sostituzione (23 pagine), Manuale di istruzioni per l'installazione (15 pagine), Manuale di installazione (14 pagine), Manuale di istruzioni per la sostituzione (18 pagine)
Stampa la pagina
Initial configuration
Step one: Connect to the console port
1
Ensure power is connected to the Cisco TS 7010 and the Status LED is green. A
status LED that is not lit indicates the unit is still booting.
2
Connect the console port of the unit to the serial port of your PC using the RJ45
to DB9 cable supplied.
3
Use a serial terminal program, such as Secure CRT or HyperTerminal, to
connect to the unit. Set your terminal software to the following settings:
Baud rate:38400
Data bits: 8
Parity:none
Stop bits:1
Flow control:none
4
Press Enter and the following command prompt appears on the terminal (where
XXXX is the model number of your Cisco TS 7010. For example,
TS-7010):
TS-XXXX:>
Step two: Configure Ethernet Port A settings
The default setting for the unit's Ethernet ports is auto-sensing mode. If the switch
ports to which you connect the Cisco TS 7010 are not also set to auto-sensing mode,
then you need to configure the Cisco TS 7010 Ethernet ports to use the same speed
and duplex mode.
To configure Ethernet Port A, enter the following for auto-sensing mode:
ethertype auto
or to configure a speed and suplex, use the following command:
ethertype <10 | 100> <half | full>
To display the current configuration and status of the Ethernet ports, enter:
status
Initial configuration
8