Cisco TelePresence Server 7010 시작하기 - 페이지 8

{카테고리_이름} Cisco TelePresence Server 7010에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Server 7010 16 페이지. 600w ac-input power supply and fan tray replacement
Cisco TelePresence Server 7010에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 설치 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Initial configuration

Step one: Connect to the console port

Ensure power is connected to the Cisco TS 7010 and the Status LED is green. A

status LED that is not lit indicates the unit is still booting.

Connect the console port of the unit to the serial port of your PC using the RJ45

to DB9 cable supplied.

Use a serial terminal program, such as Secure CRT or HyperTerminal, to

connect to the unit. Set your terminal software to the following settings:

Baud rate:38400



Data bits: 8



Parity:none



Stop bits:1



Flow control:none



Press Enter and the following command prompt appears on the terminal (where

XXXX is the model number of your Cisco TS 7010. For example,

TS-7010):

TS-XXXX:>

Step two: Configure Ethernet Port A settings

The default setting for the unit's Ethernet ports is auto-sensing mode. If the switch

ports to which you connect the Cisco TS 7010 are not also set to auto-sensing mode,

then you need to configure the Cisco TS 7010 Ethernet ports to use the same speed

and duplex mode.

To configure Ethernet Port A, enter the following for auto-sensing mode:



ethertype auto

or to configure a speed and suplex, use the following command:

ethertype <10 | 100> <half | full>

To display the current configuration and status of the Ethernet ports, enter:



status

Initial configuration