Cisco TelePresence Server 7010 시작하기 - 페이지 7

{카테고리_이름} Cisco TelePresence Server 7010에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Server 7010 16 페이지. 600w ac-input power supply and fan tray replacement
Cisco TelePresence Server 7010에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 설치 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Connecting the Cisco TS 7010

Before you start

Important:

information at http://www.cisco.com/go/telepresence/safety.

Step one: Connect power

Connect the power connector on the rear of the unit to the power supply using the

supplied power cable (there is no On/Off switch).

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch. The

Ethernet port is a 10/100/1000 Mbps auto-sensing connection.

Ethernet Ports B, C and D may not be supported in the software supplied

with your Cisco TS 7010. Do not connect to these ports unless the web

interface allows you to configure them. Do not connect multiple ports to

the same subnet unless instructed to do so by the web interface.

Before installing the unit, you must read the safety

Connecting the Cisco TS 7010