Cisco TelePresence Server 7010 Primeros pasos - Página 7
Navegue en línea o descargue pdf Primeros pasos para Hardware de red Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 16 páginas. 600w ac-input power supply and fan tray replacement
También para Cisco TelePresence Server 7010: Manual de instrucciones de sustitución (23 páginas), Manual de instrucciones de instalación (15 páginas), Manual de instalación (14 páginas), Manual de instrucciones de sustitución (18 páginas)
Imprimir página
Connecting the Cisco TS 7010
Before you start
Important:
information at http://www.cisco.com/go/telepresence/safety.
Step one: Connect power
Connect the power connector on the rear of the unit to the power supply using the
supplied power cable (there is no On/Off switch).
Step two: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch. The
Ethernet port is a 10/100/1000 Mbps auto-sensing connection.
Ethernet Ports B, C and D may not be supported in the software supplied
i
with your Cisco TS 7010. Do not connect to these ports unless the web
interface allows you to configure them. Do not connect multiple ports to
the same subnet unless instructed to do so by the web interface.
Before installing the unit, you must read the safety
Connecting the Cisco TS 7010
7