Cisco TelePresence Server 7010 Getting Started - Page 7
Browse online or download pdf Getting Started for Network Hardware Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 16 pages. 600w ac-input power supply and fan tray replacement
Also for Cisco TelePresence Server 7010: Replacement Instructions Manual (23 pages), Installation Instructions Manual (15 pages), Installation Manual (14 pages), Replacement Instructions Manual (18 pages)
Print Page
Connecting the Cisco TS 7010
Before you start
Important:
information at http://www.cisco.com/go/telepresence/safety.
Step one: Connect power
Connect the power connector on the rear of the unit to the power supply using the
supplied power cable (there is no On/Off switch).
Step two: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch. The
Ethernet port is a 10/100/1000 Mbps auto-sensing connection.
Ethernet Ports B, C and D may not be supported in the software supplied
i
with your Cisco TS 7010. Do not connect to these ports unless the web
interface allows you to configure them. Do not connect multiple ports to
the same subnet unless instructed to do so by the web interface.
Before installing the unit, you must read the safety
Connecting the Cisco TS 7010
7