Cisco TelePresence Server 7010 시작하기 - 페이지 9

{카테고리_이름} Cisco TelePresence Server 7010에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Server 7010 16 페이지. 600w ac-input power supply and fan tray replacement
Cisco TelePresence Server 7010에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 설치 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

For example, to configure a full-duplex 100Mbps link, enter:

ethertype 100 full

To establish a 1000Mbps connection, both ends of the link must be

configured as auto-sensing.

Step three: Assign an IP address to the Cisco TS 7010 (optional)

The default setting for the unit is to use DHCP to obtain an IP address. You can

assign a static IP address if you prefer or if a DHCP server is not available.

If you want the IP address of the unit to be assigned by your DHCP server, omit this

step.

To assign a static IP address, use the following command:



static <IP address> <netmask> <default gateway address>

If you do not have a DNS server, use 0.0.0.0 as the DNS server IP

address.

For example, to assign an IP address of 192.168.1.2 where the default gateway is at

192.168.1.1, enter:

static 192.168.1.2 255.255.255.0 192.168.1.1 0.0.0.0

To return to using DHCP after setting a static address, use the following



command:

dhcp

Step four: Discover the IP address of the Cisco TS 7010

To display the current status of the IP address enter:

If you have DHCP enabled on your network and you are allowing the unit to

acquire its address using DHCP, the IP address that has been acquired by

Ethernet Port A will be shown; if you have assigned a static IP address, that is the

address that will be shown.

Initial configuration

status