Cisco TelePresence Server 7010 Aan de slag - Pagina 8

Blader online of download pdf Aan de slag voor {categorie_naam} Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 16 pagina's. 600w ac-input power supply and fan tray replacement
Ook voor Cisco TelePresence Server 7010: Handleiding vervangende instructies (23 pagina's), Handleiding voor installatie-instructies (15 pagina's), Installatiehandleiding (14 pagina's), Handleiding vervangende instructies (18 pagina's)

Initial configuration

Ensure power is connected to the Cisco TS 7010 and the Status LED is green. A

status LED that is not lit indicates the unit is still booting.

Connect the console port of the unit to the serial port of your PC using the RJ45

to DB9 cable supplied.

Use a serial terminal program, such as Secure CRT or HyperTerminal, to

connect to the unit. Set your terminal software to the following settings:

Baud rate:38400



Data bits: 8



Parity:none



Stop bits:1



Flow control:none



Press Enter and the following command prompt appears on the terminal (where

XXXX is the model number of your Cisco TS 7010. For example,

TS-7010):

TS-XXXX:>

The default setting for the unit's Ethernet ports is auto-sensing mode. If the switch

ports to which you connect the Cisco TS 7010 are not also set to auto-sensing mode,

then you need to configure the Cisco TS 7010 Ethernet ports to use the same speed

and duplex mode.

To configure Ethernet Port A, enter the following for auto-sensing mode:



ethertype auto

or to configure a speed and suplex, use the following command:

ethertype <10 | 100> <half | full>

To display the current configuration and status of the Ethernet ports, enter:



status

Initial configuration