Cisco Nexus 7000 Series Manuale di installazione - Pagina 2

Sfoglia online o scarica il pdf Manuale di installazione per Server Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 16. Switch chassis
Anche per Cisco Nexus 7000 Series: Manuale di riferimento (2 pagine), Manuale di istruzioni per l'installazione (39 pagine), Riferimento (34 pagine), Manuale di installazione (18 pagine), Configurazione (8 pagine), Manuale di configurazione (28 pagine), Manuale di avvio rapido (10 pagine), Manuale di avvio rapido (29 pagine), Manuale di istruzioni per la sostituzione (14 pagine), Manuale di istruzioni per la sostituzione (21 pagine), Manuale di risoluzione dei problemi (10 pagine)

Unpacking and Inspecting a New Switch

If you are using the combined power mode or power-supply redundancy, you need only one power source. If

Note

you are using input-source redundancy or full redundancy, you need two power sources.

Unpacking and Inspecting a New Switch

Before you install a new chassis, you need to unpack and inspect it to be sure that you have all the items that

you ordered and verify that the switch was not damaged during shipment. If anything is damaged or missing,

contact your customer representative immediately.

Caution

When you handle the chassis or its components, you must follow ESD protocol at all times to prevent ESD

damage. This protocol includes but is not limited to wearing an ESD wrist strap that you connect to the earth

ground.

Tip

Do not discard the shipping container when you unpack the switch. Flatten the shipping cartons and store

them with the pallet used for the system. If you need to move or ship the system in the future, you will need

these containers.

Step 1

Compare the shipment to the equipment list that is provided by your customer service representative and verify that you

have received all of the ordered items.

The shipment should include boxes for the following:

• System chassis, which includes the following installed components:

• 1 supervisor module

• 1 I/0 module

• 1 fan tray

• 1 to 2 power supply units

• Switch accessory kit

To see a list of what is included in this kit, see .

• Cable management frames

• Left and right side frames

• Top and bottom hood frames

• M4x14 mm flat-head Phillips screws (4)

• Front door kit — Optional

• Front door (1) (69-100222-01)

Installing the Switch Chassis