ECI 1000-U LCD Manuale di installazione - Pagina 12

Sfoglia online o scarica il pdf Manuale di installazione per Controllore ECI 1000-U LCD. ECI 1000-U LCD 18.

6.3.8 Technical Support Menu

Selecting Technical Support displays Technical support contact information and the software revision.

Selecting Rotate display will flip the display 180°

Be sure all power is turned off to the operator before

starting installation.

The ECI 1000U LCD board replaces three different

boards. Follow the appropriate procedure for the board

being replaced.

1. Switch power to the door operator off and wait for the capacitors to discharge.

2. Remove the cover to access the door board

3. Unplug all connectors from the existing board.

4. Unscrew the four nuts holding the existing board in place and remove board.

5. Install the ECI 1000U LCD board and secure board in place.

6. Plug in all connectors

7. Connect the ground wire to X13 pin 1 ( unlabeled pin) of ECI 1000U LCD board

8. Ensure the TEST/RUN switch is in the TEST position and the OPEN/CLOSE and

NUDGE/LOCK switches are in center positions.

9. Perform Section 8 Initial Power up and Adjustments

1. Switch power off to door operator and wait for capacitors to discharge

2. Remove cover to access door board.

3. Unplug connectors from existing board.

4. Disconnect L1A and L2A from existing board and connect to X12 (2 pin connector) for the ECI

1000U LCD board.

5. Disconnect all wires from J2 (old board) and connect to X13 (7 pin connector) for ECI 1000U

LCD board: DO3, DO10, D07, D04, DO18, DO17.

6. Remove 0V yellow wire form J4 connector (old board) and connect to 0V pin of 6 pin connector

for ECI 1000U LCD board.

7. Remove RB1, RB2, A1, A2 from old board and connect to 6 pin connector for those same

signals of the ECI 1000U LCD board.

8. Disconnect –VS from the old board and remove the old board.

ECI 1000-U LCD Installation Manual

Electronic Controls, Inc.

7073 North Atlantic Ave. Cape Canaveral, FL 32920

800-633-9788

www.eciamerica.com

P a g e

| 12