ECI 1000-U LCD Manuale di installazione - Pagina 14

Sfoglia online o scarica il pdf Manuale di installazione per Controllore ECI 1000-U LCD. ECI 1000-U LCD 18.

a. The doors should start moving and the DRIVE and MOTOR reading in the

DIAGNOSTICS menu should increase. If the doors do not move refer to section ??????

b. When the doors are fully open the DRIVE and MOTOR readings should go to 0 and the

OL LED should light

6. Set the OPEN/CLOSE switch to the CLOSE position.

The doors should start moving in the CLOSE direction and the MOTOR and DRIVE

readings should increase. If the doors do not move refer to section ????

b. When the doors are fully closed the MOTOR and DRIVE readings should go to 0 and the

CL LED should light.

8.2 Door Adjustments

This equipment is to be installed, adjusted and maintained to conform to code requirements. Parameters

must be set to conform to kinetic energy code limitations for both maximum and average kinetic energy

for ALL doors/all floors (specialty or otherwise heavy doors taken into account).

Parameters must be set to conform to closing force limitations. The closing force may not exceed 135N

(30lbs). During the closing, the kinetic energy may not exceed 10 joules (7.4lb/ft)

Select the EDIT PARAMETERs menu

At this time adjustments can be made to open and close speeds by moving the cursor to the desired setting

and pressing the ENTER button. Any changes happen in real time so there is no need to press enter for

each change. When complete press the ENTER button and move to the next parameter. Refer to Figure 4

for an example of OPEN and CLOSE cycles.

To adjust NUDGING set the NUDGE/LOCK switch to the NUDGE position then set the OPEN/CLOSE

switch to CLOSE.

To adjust DOOR LOCKING FORCE (DLF) have the door fully closed. Set the NUDGE/LOCK switch

to LOCK then set the OPEN/CLOSE switch to the CLOSE position.

1. Heavy door adjustments must be made at a heavy door entrance.

2. Check that there is 24VDC at connector X7 pins HDP and HDN.

3. Starting from a fully open position, TEST/RUN switch in TEST, set the OPEN/CLOSE switch to

CLOSE and adjust the CFH (Close Fast Heavy door) parameter. Adjust the HDCSDL cam for

smooth operation if required.

ECI 1000-U LCD Installation Manual

Electronic Controls, Inc.

7073 North Atlantic Ave. Cape Canaveral, FL 32920

800-633-9788

www.eciamerica.com

P a g e

| 14