Whirlpool WGD6400SW0 Scheda tecnica - Pagina 2

Sfoglia online o scarica il pdf Scheda tecnica per Asciugatrice Whirlpool WGD6400SW0. Whirlpool WGD6400SW0 12. 29" gas dryer
Anche per Whirlpool WGD6400SW0: Elenco delle parti (8 pagine), Manuale di avvio rapido (6 pagine)

Stampa la pagina

TECH SHEET - DO NOT DISCARD

Power button controls

Status indicators at right.

Rotating knob turns

indicators on or off.

"Less Time" button

"More Time" button

turns the right digit of

turns the left digit of

the display on or off.

Figure 1. Console Diagnostics.

DIAGNOSTIC: Motor, Heater, and Console ID

Close the door. Press the Start button. The motor and heater will

turn on, and the display will show one of the following console IDs:

C6, C7

If none of the Console IDs above are displayed, replace the

user interface assembly. See Accessing & Removing the

Electronic Assemblies, page 11.

If the motor does not turn on, go to TEST #3, page 6.

If no heat is detected, go to TEST #4, page 7.

DIAGNOSTIC: Displaying Line Voltage

Used to display the line voltage currently being measured by the

machine control:

After all saved fault codes have been displayed, press the Cycle

Signal button. The last 2 digits of the voltage value will be

displayed on the dual 7-segment display.

A Dryness modifier LED will also be illuminated to indicate the

voltage range corresponding to the number displayed. The

Dryness LEDs relate to specific voltage ranges as follows:

The More LED will be illuminated for high voltage readings

(above 132 VAC).

The Normal LED will be illuminated for normal voltage readings

(90-132 VAC).

The Less LED will be illuminated for low voltage readings

(below 90 VAC).

DEACTIVATING THE DIAGNOSTIC TEST MODE

Press the Pause/Cancel button twice to exit diagnostics.

FOR SERVICE TECHNICIAN'S USE ONLY

Dryness button controls

all indicators above button.

, or

Temperature button controls

Each button controls

all indicators above button.

its own indicator.

ACTIVATING THE MANUAL LOAD TEST

1. Be sure the dryer is in standby mode (plugged in with all

indicators off, or with only the Clothes Dry indicator on).

2. Select any one button (except Pause/Cancel) and follow the

steps below, using the same button (remember the button):

Press/

Release

Press/

hold 2-5

for 2-5

hold 2-5

seconds

flashes momentarily, the motor starts right away, and the

Heavy Duty LED flashes (this step starts the Manual Load

sequence):

1. Turn on motor.

Flash "Heavy Duty" LED.

Now press any key (except Pause/Cancel) and the control will

advance through each step of the following sequence:

2. Motor + heater.

3. No loads on (motor + heater off).

4. Repeat using same button.

DEACTIVATING THE MANUAL LOAD TEST

Press the Pause/Cancel button to exit this mode.

Start button turns on dryer.

Turns off all indicators and

exits diagnostic mode.

Release

Press/

Release

for 2-5

hold 2-5

for 2-5

seconds

Flash "Casual" LED.

Flash "Normal" LED.

Start sequence again at 1.

PART NO. W10054160

PAGE 2

Press/

hold 2-5

seconds