3Com OfficeConnect WX1200 Manuale di avvio rapido - Pagina 5
Sfoglia online o scarica il pdf Manuale di avvio rapido per Hardware di rete 3Com OfficeConnect WX1200. 3Com OfficeConnect WX1200 10. Secure converged networks enterprise edition
Anche per 3Com OfficeConnect WX1200: Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (10 pagine), Scheda tecnica (6 pagine), Manuale del prodotto (15 pagine)
Stampa la pagina
Figure 1 Single-Switch Deployment
Console
Port
2
MAP
alice
user1
To run the quickstart command:
Attach a PC to the WX switch's serial console port.
1
(Use these modem settings: 9600 bps, 8 bits, 1 stop,
no parity, hardware flow control disabled.)
Press Enter three times, to display a username prompt
2
(Username:), a password prompt (Password:), and
then a command prompt such as the following:
WX1200>
Access the enabled level (the configuration level) of
3
the CLI:
WX1200> enable
WX1200-C orp
10.10.10.4
Port
3
MAP
user2
Backbone
Corporate resources
bob
Press Enter at the Enter password prompt.
4
Type quickstart. The script asks you a series of ques-
5
tions. You can type ? for more help. To quit, press
Ctrl+C.
One of the questions the script asks is the country
code. For a list of valid country codes, see the
less LAN Switch and Controller Installation and
Basic Configuration Guide
listed in the "Configuring a WX Switch for Basic Ser-
vice" chapter, in the "Specifying the Country of Oper-
ation" section.
Using the quickstart Command
Internet
. The country codes are
5
Wire-