3Com OfficeConnect WX1200 Skrócona instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt sieciowy 3Com OfficeConnect WX1200. 3Com OfficeConnect WX1200 10 stron. Secure converged networks enterprise edition
Również dla 3Com OfficeConnect WX1200: Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (10 strony), Arkusz danych (6 strony), Instrukcja obsługi produktu (15 strony)

Figure 1 Single-Switch Deployment

Console

Port

MAP

alice

user1

To run the quickstart command:

Attach a PC to the WX switch's serial console port.

(Use these modem settings: 9600 bps, 8 bits, 1 stop,

no parity, hardware flow control disabled.)

Press Enter three times, to display a username prompt

(Username:), a password prompt (Password:), and

then a command prompt such as the following:

WX1200>

Access the enabled level (the configuration level) of

the CLI:

WX1200> enable

WX1200-C orp

10.10.10.4

Port

MAP

user2

Backbone

Corporate resources

bob

Press Enter at the Enter password prompt.

Type quickstart. The script asks you a series of ques-

tions. You can type ? for more help. To quit, press

Ctrl+C.

One of the questions the script asks is the country

code. For a list of valid country codes, see the

less LAN Switch and Controller Installation and

Basic Configuration Guide

listed in the "Configuring a WX Switch for Basic Ser-

vice" chapter, in the "Specifying the Country of Oper-

ation" section.

Using the quickstart Command

Internet

. The country codes are

Wire-