3Com OfficeConnect WX1200 Manual de início rápido - Página 5
Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede 3Com OfficeConnect WX1200. 3Com OfficeConnect WX1200 10 páginas. Secure converged networks enterprise edition
Também para 3Com OfficeConnect WX1200: Manual de início rápido (2 páginas), Manual de início rápido (10 páginas), Ficha de dados (6 páginas), Manual do produto (15 páginas)
Imprimir página
Figure 1 Single-Switch Deployment
Console
Port
2
MAP
alice
user1
To run the quickstart command:
Attach a PC to the WX switch's serial console port.
1
(Use these modem settings: 9600 bps, 8 bits, 1 stop,
no parity, hardware flow control disabled.)
Press Enter three times, to display a username prompt
2
(Username:), a password prompt (Password:), and
then a command prompt such as the following:
WX1200>
Access the enabled level (the configuration level) of
3
the CLI:
WX1200> enable
WX1200-C orp
10.10.10.4
Port
3
MAP
user2
Backbone
Corporate resources
bob
Press Enter at the Enter password prompt.
4
Type quickstart. The script asks you a series of ques-
5
tions. You can type ? for more help. To quit, press
Ctrl+C.
One of the questions the script asks is the country
code. For a list of valid country codes, see the
less LAN Switch and Controller Installation and
Basic Configuration Guide
listed in the "Configuring a WX Switch for Basic Ser-
vice" chapter, in the "Specifying the Country of Oper-
ation" section.
Using the quickstart Command
Internet
. The country codes are
5
Wire-