Clarke Metalworker CBS45MD Manuale d'uso e manutenzione - Pagina 15

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Sega Clarke Metalworker CBS45MD. Clarke Metalworker CBS45MD 19. 6” (152mm) bandsaw

8. ADJUSTING BLADE ANGLE

When horizontal cutting, the blade must be at right angles (or vertical) to the

bed. To achieve this:

Loosen the screw (A, Fig.4).

Adjust the blade guide (B, Fig.4) to make the blade vertical to the bed.

Place can engineers square on the bed to check the blade Is vertical, It not,

repeat the process. 1 to 3.

Tighten the screw (11)

All bearings are lubricated for life. It is not necessary therefore to lubricate guide

bearings etc.

A thin film of oil on all unpainted surfaces will protect your saw and prevent

oxidation.

Lubricate all screw threads regularly, depending upon useage.

The drive gears run in an oil bath and will not require a lubricant change more

often than once a year.

When needing a change, first lower the arm to a horizontal position, then remove

the 4 screws securing the gearbox cover.

Open the cover (item 6).

Place a container under the right lower corner of the gear box, slowly raise the

head until the oil flows into the container.

Lower the head then wipe up excess oil and foreign matter with a soft rag, then

add Iubricant into the box until it is full. Close the cover, and tighten the 4 screws.

Fig.4