Clarke Metalworker CBS45MD Manuale d'uso e manutenzione - Pagina 16

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Sega Clarke Metalworker CBS45MD. Clarke Metalworker CBS45MD 19. 6” (152mm) bandsaw

Method Of Operation

Raise the arm to the vertical position.

Open the vice to accept the piece to be cut by rotating the wheel at the end of

the base anticlockwise.

Place the workpiece on the saw bed. If the piece Is long it should be supported.

Clamp the workpiece securely in the vice by turning the hand wheel clockwise.

Switch on the machine, allow the head to lower slowly on to the work. Do not

drop or force.

Let the weight of the saw head provide the cutting force.

The weight of the head is regulated by turning the handle (item L). This effects

spring tension which in turn acts to balance the weight of the head and therefore

the cutting force.

The saw automatically shuts off at the end of the cut. The point at which this

occurs is effected by moving the plate shown in Fig.3 so that it makes contact

with the OFF switch sooner or later as required.

To use this saw In the vertical cutting position, the table must be fitted and the

main saw body locked in the vertical position.

Locking the Saw In Vertical Position

Rotate the bracket (item T/74) to an upright position,

locate in notch on saw arm and tighten. if you have

difficulty in locating this bracket in thenotch,

adjust screw at bottom of sawuntil

bracket locates, then tightenbracket.

Fitting the table

Loosen the screws A from the blade

guide,and remove the blade guard.

Locate the table support (item 40) and

attach it to the bolt K, Fig.1.

Place the table on top of the guide

assembly and insertbolts A and B Fig.5, and tighten fully.

CAUTION:

ALWAYS use a push stick to guide the work pst the blade

when cutting in vertical mode.

(see Fig 5):

Fig.5