3Dlabs X400 Manuale di avvio rapido e di riferimento - Pagina 16

Sfoglia online o scarica il pdf Manuale di avvio rapido e di riferimento per Stampanti 3D 3Dlabs X400. 3Dlabs X400 16.

TROUBLESHOOTING

1) Your bed and nozzle gap have been calibrated from the factory. But if you see that the first layer of

the print is smashing down, or not sticking to the bed, this may mean that the distance between the

nozzle and bed is either too far away, or too close.

You can adjust the distance of the nozzle from the bed in real time to get a perfect first layer.

2) Click "Controls" on the print screen

3) Click Babystep and use the up and down arrows to adjust the nozzle gap. START WITH THE

SMALLEST INCREMENTS AT FIRST. THERE MAY ALSO BE A DELAY IN THE ADJUSTMENT, SO BE

PATIENT.

Page | 16