3Dlabs X400 빠른 시작 및 참조 매뉴얼 - 페이지 16

{카테고리_이름} 3Dlabs X400에 대한 빠른 시작 및 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Dlabs X400 16 페이지.

TROUBLESHOOTING

1) Your bed and nozzle gap have been calibrated from the factory. But if you see that the first layer of

the print is smashing down, or not sticking to the bed, this may mean that the distance between the

nozzle and bed is either too far away, or too close.

You can adjust the distance of the nozzle from the bed in real time to get a perfect first layer.

2) Click "Controls" on the print screen

3) Click Babystep and use the up and down arrows to adjust the nozzle gap. START WITH THE

SMALLEST INCREMENTS AT FIRST. THERE MAY ALSO BE A DELAY IN THE ADJUSTMENT, SO BE

PATIENT.

Page | 16