DockStar Smart Thruster Manuale di installazione - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione per Attrezzatura per la nautica DockStar Smart Thruster. DockStar Smart Thruster 16. Stern
Anche per DockStar Smart Thruster: Manuale operativo (15 pagine)
Stampa la paginathe main engine(s) thrust. For single engine boats this means mounting the Smart Thruster off the
center line. For twin engine boats, this means mounting the Smart Thruster closer to the center line.
The boat owner must determine whether there is adequate clearance from all objects to be able to
mount the Smart Thruster to the stern of their boat.
Getting Started
The Smart Thruster is mounted to the stern of your boat by first mounting a stainless tube and T-track
assembly to your stern and then sliding the Smart Thruster up and down on this T-track. The T-track
assembly is mounted in one of the four configurations described below. Each configuration is described
in its own section of this document.
Configuration 1: Top and bottom mounted directly to hull
For this configuration, the top and bottom deck
hinges are mounted using the 10-32 flat-head
through-bolts provided. The bottom fixture should be
located as low on the stern as possible, but should be
no less than about 4 inches from the center of the
hinge to the water line.
The flat-head screws should be secured with the
fender washers and nylock nuts provided. 3" flat
head screws are provided. These may be too long for
your installation. These may either be cut to the
proper length or proper length stainless steel 10-32
screws can be purchase from your local marine or hardware store.
It is a good idea to use a good marine sealant under the fittings when doing the final installation.
The "Stern Hull-Mount Installation Kit" is shown in the picture below:
Page 2/ 16