- ページ 6

ウォーターヒーター FloatPac RainPacのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。FloatPac RainPac 16 ページ。 Under house and decking flexible rainwater harvesting bladder tanks

ページを印刷する

INSTALLATION:

Points covered:

Levelling of selected site;

Unpacking the RainPac

Inlet bladder connection;

Outlet bladder connection; and,

Installing the downpipe diverter, overflow and connection to the RainPac FloatPac.

1. Level the selected site with a spirit level and a piece of timber, which should ideally be the width of the area you have selected. Check and recheck

the levelled area for anything sharp or dangerous that could harm the bladder (and its installer!).

Carefully remove the RainPac

fittings are. This is the end that is closest to the downpipe/s. The RainPac

box and lay out flat.

Please note: As the RainPac

(4") Hansen inlet is facing towards the ground. The 2" (50mm) vent fitting in the centre of the RainPac

towards the sky. Also, do not be concerned if when you roll the bladder out it looks too wide for the area – as the bladder moves in at the sides as it

fills, it will not cause any damage to the bladder or surrounding joiners/bearers and foundations.

PLEASE MAKE SURE THE INLET FITTING IS FACING THE GROUND ONCE INSTALLATION IS COMPLETE

and rolling out onsite;

from its box and separate the fitting kit from the bladder. The end that you will first see is the end where all the

has been rolled up the correct way, it is very easy to install. Make sure that once the bladder is laid out flat, the 100mm

has been rolled the correct way so you can simply remove it from the

is the only fitting that should be facing

P a g e

6 | 15