- ページ 4

試験装置 Dongguan Xin Bao Instrument XB-OTS-106のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Dongguan Xin Bao Instrument XB-OTS-106 6 ページ。 Elmendorf tearingstrengthtester

ページを印刷する

Dongguan Xin Bao Instrument Co., Ltd

II. Specification

 Range of tearing strength: 0~16N

A：0~32N (Small hammer A)

B：0~64N (Big hammer B)

 Tearing length: 43mm

 Line length of cutting: 20mm±0.2mm

 Specimen size: 100（L）mm×63（W）mm

 Accuracy of measuring strength: ≤±1(scale mark)

 External Size: 400mm×210mm×395 mm

 Weight：About 30kg

III. Installation

1.In order to prevent the swing of hammer 4 during the transportation, the fan-shaped fan and the

bearing base are fixed by a screw. Please remove it before using the instrument.

2. After removing the screw, the instrument must be put on a solid and stable bench. It is better to put

hard rubber sheet( 2mm ~ 3 mm) between the instrument and bench.

IV. Adjustment

 Adjust the jack screw 1 to make the bubble on the center pf spirit level 11.

 Clamp the specimen and tilt the tearing knife 9. The line length of the specimen should be 20mm

± 0.2mm. If the length doesn't reach to 20mm ± 0.2mm, please adjust the position of the knife.

 Raise the fan-shaped hammer 4. On the 25mm of the braking point's right, please make a pointer

(It can be make by a wire but it can not be close with fan-shaped hammer 4), then dial the pointer

aside to the zero position. Tilt the test spanner 8, the baffle of the fan-shaped hammer 10 will be

pressed so that make the fan-shaped hammer 4 swing freely. Observe the decay within the twenty

cycles. The amount should be less than 25mm. Or you have to add the oil in the bearing to make it

flexible.

 When the fan-shaped hammer 4 is raising, please dial the pointer to the left of the pointer baffle

13.Tilt the test spanner 8 to make the fan-shaped hammer 4 swing freely. Please grasp the

Add: The 3rd Industrial Zone, Chashan Town, Dongguan. Tel: 0769-33365786 www.ots-testequipment.net