Dongguan Xin Bao Instrument XB-OTS-106 Manual de operação - Página 4
Procurar online ou descarregar pdf Manual de operação para Equipamento de teste Dongguan Xin Bao Instrument XB-OTS-106. Dongguan Xin Bao Instrument XB-OTS-106 6 páginas. Elmendorf tearingstrengthtester
Imprimir páginaDongguan Xin Bao Instrument Co., Ltd
II. Specification
Range of tearing strength: 0~16N
A：0~32N (Small hammer A)
B：0~64N (Big hammer B)
Tearing length: 43mm
Line length of cutting: 20mm±0.2mm
Specimen size: 100（L）mm×63（W）mm
Accuracy of measuring strength: ≤±1(scale mark)
External Size: 400mm×210mm×395 mm
Weight：About 30kg
III. Installation
1.In order to prevent the swing of hammer 4 during the transportation, the fan-shaped fan and the
bearing base are fixed by a screw. Please remove it before using the instrument.
2. After removing the screw, the instrument must be put on a solid and stable bench. It is better to put
hard rubber sheet( 2mm ~ 3 mm) between the instrument and bench.
IV. Adjustment
Adjust the jack screw 1 to make the bubble on the center pf spirit level 11.
Clamp the specimen and tilt the tearing knife 9. The line length of the specimen should be 20mm
± 0.2mm. If the length doesn't reach to 20mm ± 0.2mm, please adjust the position of the knife.
Raise the fan-shaped hammer 4. On the 25mm of the braking point's right, please make a pointer
(It can be make by a wire but it can not be close with fan-shaped hammer 4), then dial the pointer
aside to the zero position. Tilt the test spanner 8, the baffle of the fan-shaped hammer 10 will be
pressed so that make the fan-shaped hammer 4 swing freely. Observe the decay within the twenty
cycles. The amount should be less than 25mm. Or you have to add the oil in the bearing to make it
flexible.
When the fan-shaped hammer 4 is raising, please dial the pointer to the left of the pointer baffle
13.Tilt the test spanner 8 to make the fan-shaped hammer 4 swing freely. Please grasp the
Add: The 3rd Industrial Zone, Chashan Town, Dongguan. Tel: 0769-33365786 www.ots-testequipment.net
2