ページを印刷するHEADER SPLICE (OPTIONAL)
-If the header is in two or more pieces, insert an equal amount of the provided header splice into each of the square ends of the
headers and secure as shown using (12) #8 x 3/4" HWH #2 Tek Screws (see Fig. S-1).
-Be sure to place a post under the splice (see Fig. S-2).
#8 x 3/4" HWH #2 Tek Screw
Header
Fig. S-1
LATTICE SPLICE (OPTIONAL)
-If the lattice is in two or more pieces, insert a lattice splice into the ends of two tubes and secure with (2) #8 x 3/4" HWH
#2 Tek screws (see Fig. S-3).
Header Splice
#8 x 3/4" HWH #2 Tek Screw
Lattice Tube
Fig. S-3
Fig. S-2
Lattice Splice