- ページ 2
水ポンプ Akw M17 DigiPumpのPDF 設置および使用上の注意をオンラインで閲覧またはダウンロードできます。Akw M17 DigiPump 20 ページ。 Digipump
ページを印刷するContents
M-SERIES DIGIPUMPS
M-SERIES DIGIPUMPS
The M series Digipump and sensor kits has been designed for the pumping of shower waste
water. The Digipump control unit uses flow sensors to measure the flow rate of water into the
shower. The control unit uses the signals sent from the flow sensors to adjust the pump speed
automatically to match the flow of water from the shower. When the shower is turned off, the
flow sensors send a signal to the control unit and after a pre-set time delay the pump turns off.
After a further set time the pump will automatically switch on for a short period of time at a
reduced pumping speed, removing any run off water pooled in the shower area and gully. The
pump has the ability to run dry without causing damage. Non-return valves in the pump head
prevent smells from entering the bathroom area from the waste pipe.
Declaration of Conformity
Declaration of Conformity
We declare that the AKW M17 DigiPump shower waste water pump conforms to the
requirements of the EMC Directive 2014/30/EU, LVD Directive 2014/35/EU and the
following harmonised European and national standards in the confirming assessment.
EN 60335-1
EN 60335-2-41
EN 62233
EN 61000-3-2
EN 61000-3-3
EN 55014-1
EN 55014-2
AKW Ltd.
2
Page
2
3
4
4
5-7
8
9
10-11
12-13
14
15
16
17