- ページ 8
投影スクリーン Draper FoundationのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Draper Foundation 17 ページ。 Foundation for led panels
ページを印刷する
Foundation
for LED Panels
™
Section 6 - Adjusting and Aligning Horizontal Rails
1. Push the wall brackets against the wall where they will be mounted. Depending on the flatness of the wall some brackets may not touch the wall
TOP VIEW -
Laser Line
Fig. 6-1
TOP VIEW -
Laser Line
2. For any wall brackets not touching the wall
(see BLUE CIRCLES
ABOVE)
on the top and bottom of each bracket
.
(See Fig. 6-2)
3. Using a 3mm Hex Wrench, turn the two
adjustment set screws on each wall mounting bracket.
(2)
Adjust the wall bracket back until it touches the wall
.
(see Fig. 6-3)
PLEASE NOTE: Take care not to adjust too far and force any wall brackets off the wall that were touching it.
A level or straight edge can also be laid across the front face of the horizontal rail
between 3 or more wall brackets to ensure the rail is straight.
4. Leaving the wall brackets free floating, shine a laser line parallel to the desired viewing surface
of the LED wall and close to the horizontal rails.
5. Using a tape measure check the distance from the laser line to the horizontal rail at each wall bracket,
and adjust any wall brackets until all measurements match.
6. Once all brackets are in contact with the wall, and the horizontal rails are perfectly straight, tighten all adjustment screws.
CONCAVE WALL
CONVEX WALL
use a 5mm Hex Wrench to loosen the four
locking screws
(4)
3mm Hex
Wrench
page 14 of 32
Section 7 - Securing Inner Wall Brackets
.
1. Secure each bracket to the wall with the appropriate mounting hardware.
(see Fig. 6-1)
2. Check the distance from the laser line at each wall bracket to ensure nothing moved while fastening to the wall. Adjust if necessary.
3. Carefully tighten all four
Fig. 6-2
Section 8 - Attaching Wall Adjuster Brackets to Vertical Rails
Fig. 6-3
Section 8.1 - For LED arrays up to 6 panels high - 2 Horizontal Rails
WORK GLOVES
RECOMMENDED
1. Attach the Differential Screw to the Wall Adjustment Bracket.
1
E S
O V
T M
L
A L
K E
S W
A C
R D
B R
W A
T O
WALL ADJUSTER
Attach Differential Screw
using 3mm Hex Wrench
Fig. 6-4
2. Attach two
Wall Adjuster Brackets to the back side using a 3mm hex wrench.
(2)
2
Foundation
for LED Panels
™
locking screws on the top and bottom of each wall mounting bracket.
(4)
BRACKET
ASSEMBLY
Back
TOP
page 15 of 32
3mm Hex
Wrench
engaged with
differential
screw