Premier
Section 10 - Wiring Diagrams: Motor with internal low-voltage controller
110-120V MOTOR AND QUIET MOTOR
110-120V Motor
(Motor with internal low-voltage controller)
(Internal Low-Voltage Controller for ILT motor)
Single Station Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Data Cable
Dashed wiring
by electrician.
RJ-9
connector
Wall Switch,
RF or IR
Receiver,
or integrated
control system.
To 110-120V Line
Motor with Internal Low-Voltage Controller: Switch-to-Motor
Back of
wall switch.
Please Note: 5V DC must be
connected to be able to set
limits using the wall switch.
Multiple Station Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Dashed wiring
by electrician.
Data Cables
RJ-9
connector
Wall Switch,
RF or IR
Receiver,
or integrated
control system.
To 110-120V Line
INSERT MOTOR DATA
CABLE HERE
Plug & Play 110-120V Motor
Single Low-Voltage Control
110-120V
Plug
(Dry Contacts or Data Cable connection)
CAUTION: Although both Dry Contact and Data Cable
connections are shown, only one connection type
per motor should be used.
Please Note:
• This Splitter/Jack is located inside the motor-end
endcap of screen. To access, remove access panel
from endcap.
• Data Cables to switches or to additional motors can be
plugged into any of the three open jacks.
(Motor with internal low-voltage controller)
Multiple Low-Voltage Controls
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Data
Cable
Wall Switch,
RF or IR
Receiver,
or integrated
110-120V
control system.
Plug
control systems.
page 7 of 7
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Data
Cables
Wall Switches,
RF or IR
Receivers,
or integrated
ページを印刷する