- ページ 3
室内装飾品 Draper FlexShade NEXDのPDF 説明書 インストールと操作をオンラインで閲覧またはダウンロードできます。Draper FlexShade NEXD 8 ページ。 Clutch-operated small and large hardware
Draper FlexShade NEXD にも： 取付・取扱説明書 (6 ページ), 取扱説明書 (8 ページ), 説明書 インストールと操作 (8 ページ), 説明書 インストールと操作 (10 ページ), 取扱説明書 (12 ページ)
ページを印刷する
Bottom-Up FlexShade
Small and Large Hardware
Please Note: If installing Pocket Headbox or Surface Headbox, please install headbox FIRST
Section 1 - Endcap Covers
Caution: Before mounting shades, verify measurements on label provided with shade,
and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site
conditions.
Snap endcap covers into place as shown in Fig. 1.
Figure 1
Section 3 - Mounting Endcaps
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1. Mark wall, ceiling, or jamb for placement of endcaps.
2. Drill small starter hole
(if necessary)
Please Note: Window Side Safety Bracket
Figure 3
NEXD,
®
3. Attach idler and operator endcap covers to endcaps.
in mounting surface.
4. Mount endcaps using appropriate fasteners for surface.
MUST be installed on Idler Endcap at this time when Ceiling or Jamb Mounting.
(s)
Section 2 - Converting Between
Left and Right Mounting
Configurations on Wall
Mount Endcaps
1. Remove screws and small metal mounting plate
from reverse side of endcap.
2. Insert small metal mounting plate into slots on
other side of endcap, and use screws to reattach
mounting plate to endcap.
1.
Figure 2
2.
(Section 6, P. 5)
PLEASE NOTE:
If endcaps are
included in order,
drill through endcap
cover and secure
with endcap.
Endcap requires
a minimum of
two fasteners.
It is not necessary
to utilize all four
corners.
page 3 of 8
.
(Section 13)
(Fig. 2)
.