- ページ 8

オーブン Bosch Vision 800 SeriesのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Bosch Vision 800 Series 28 ページ。 Gas slide-in ranges
Bosch Vision 800 Series にも：取扱説明書 (40 ページ), 寸法と仕様 (2 ページ), インストレーション・マニュアル (6 ページ), サービスマニュアル (43 ページ), サービスマニュアル (36 ページ)

Inlet Water Connections

Hot Water Supply

The hot water heater should be set to deliver approximately

120° F (49° C) water to the dishwasher. Water that is too

hot can cause some detergents to lose effectiveness. Lower

water temperatures will increase run times. The hot water

supply pressure must be between 15 - 145 psi (1 - 10 bar).

IMPORTANT NOTES:

sure to make all solder connections before connecting the

water supply line to the dishwasher.

· Always use the appropriate seal when making plumbing

connections.

· Before connecting the water supply line to the dishwasher,

to clear any foreign material.

· Turn on the water supply and check for leaks after

connections are made.

WARNING

Avoid Scald Hazard

Do not perform any work on a charged hot water

plumbers should perform plumbing work. Do not

attempt any work on the dishwasher hot water

supply plumbing until you are certain the hot water

supply is shut off.

Temperatures required for soldering and sweating

will damage the dishwasher. If plumbing lines

are to be soldered or sweated, keep the heat

source at least 6 inches (152.4 mm) away from

the dishwasher.

Water Supply Shut Off Valve

Install an easily accessible shut-off valve (not supplied) in

the hot water supply line, as shown in Figure 8. All solder

connections must be made before the water line is connected

to the dishwasher.

Connecting the Hot Water Supply

There are two plastic corrugated hoses that exit the back of

end, is the water supply hose to the dishwasher (the other

(76 x 45 mm) opening through the cabinet to pass the dish-

washer water supply line through toward the shut off valve.