Bosch Vision 800 Series Kurulum Talimatları Kılavuzu - Sayfa 8
Fırın Bosch Vision 800 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Bosch Vision 800 Series 28 sayfaları. Gas slide-in ranges
Ayrıca Bosch Vision 800 Series için: Kullanım Kılavuzu (40 sayfalar), Boyutlar ve Özellikler (2 sayfalar), Kurulum Kılavuzu (6 sayfalar), Servis Kılavuzu (43 sayfalar), Servis Kılavuzu (36 sayfalar)
Sayfayı Yazdır
Inlet Water Connections
Hot Water Supply
The hot water heater should be set to deliver approximately
120° F (49° C) water to the dishwasher. Water that is too
hot can cause some detergents to lose effectiveness. Lower
water temperatures will increase run times. The hot water
supply pressure must be between 15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
sure to make all solder connections before connecting the
water supply line to the dishwasher.
· Always use the appropriate seal when making plumbing
connections.
· Before connecting the water supply line to the dishwasher,
to clear any foreign material.
· Turn on the water supply and check for leaks after
connections are made.
WARNING
Avoid Scald Hazard
Do not perform any work on a charged hot water
plumbers should perform plumbing work. Do not
attempt any work on the dishwasher hot water
supply plumbing until you are certain the hot water
supply is shut off.
Temperatures required for soldering and sweating
will damage the dishwasher. If plumbing lines
are to be soldered or sweated, keep the heat
source at least 6 inches (152.4 mm) away from
the dishwasher.
Water Supply Shut Off Valve
Install an easily accessible shut-off valve (not supplied) in
the hot water supply line, as shown in Figure 8. All solder
connections must be made before the water line is connected
to the dishwasher.
Connecting the Hot Water Supply
There are two plastic corrugated hoses that exit the back of
end, is the water supply hose to the dishwasher (the other
(76 x 45 mm) opening through the cabinet to pass the dish-
washer water supply line through toward the shut off valve.
8
/
3
4
8