- ページ 15

試験装置 Andatech PRODIGYのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Andatech PRODIGY 20 ページ。

BLUETOOTH

Check the bluetooth printer status. If the printer is switched

on and connected, the State will display "Working". If the

State displays "None", ensure the printer is on and press

"MATCH" .

Note: It may take several seconds for the connection to

complete.

TROUBLESHOOTING

'CALIBRATION NEEDED' WARNING

When the unit starts up and shows the "Calibration Needed"

warning and alarm, it means the unit has passed its calibration

due date. The unit can continue to be used by touching the

screen, however it is strongly recommended that it be sent to

us for calibration.

BATTERY LIFE TOO SHORT

Use only alkaline batteries, and if using rechargeable batteries,

use either NiMH or rechargeable alkaline batteries.

TOUCH SCREEN NOT RESPONDING

If the touchscreen is not sensitive enough, calibrate the screen

by pressing and holding the On/Off button (right button)

immediately followed by the Function button (left button). Then

follow the on-screen instructions.

CLEAN AIR TEST CONTINUES TO DETECT

ALCOHOL

Let the device sit for 5 minutes to clear out any possible

residue. If the problem persists, contact Andatech.