- ページ 18

ステレオシステム Bose L1 Model IIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose L1 Model II 32 ページ。 Portable line array systems
Bose L1 Model II にも：オーナーズマニュアル (32 ページ), オーナーズマニュアル (28 ページ), テクニカル・データシート (8 ページ), テクニカル・データシート (8 ページ), アプリケーション・マニュアル (13 ページ), マニュアル (15 ページ)

ETUP

Connecting a B1 bass module to the L1 model I power stand (optional)

Figure 5

Bass module orientations

Figure 6

B1 bass module

The B1 Bass Module jack on the L1 model I power stand can adequately drive one or two B1

bass modules. B1 bass modules can be placed on the floor vertically or horizontally. Up to

four modules can be stacked when placed horizontally (Figure 5).

CAUTION: Do not connect more than two B1 bass modules to the B1 Bass Module jack on the

L1 model I power stand. Driving more than two B1 bass modules from the B1 Bass Module out-

put will improperly load the amplifier in the L1 model I power stand, resulting in less than full sys-

tem performance.

CAUTION: Only B1 bass modules should be used in the B1 Bass Module jack.

B1 bass modules can

be placed vertically or

horizontally

Insert one end of the B1 bass module 4-wire cable into one of the jacks on the rear panel

of the B1 bass module. Insert the other end of the 4-wire cable into the B1 Bass Module jack

on the L1 model I power stand connector panel.

To connect, push the plug

into the jack and rotate it

clockwise to lock it.

To disconnect, slide back the metal tab on the

body of the plug, rotate the plug counterclockwise

and pull it out of the jack.

Note: The B1 bass module connector will click softly upon being properly engaged.

CAUTION: A B1 bass module cannot be shared between two L1 model I power stands.

B1 bass modules can

be stacked in a column

of up to four, maximum

B1 Bass Module

B1 bass module 4-wire cable (blue)