- ページ 5

医療機器 3M Litmann Quality 3100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。3M Litmann Quality 3100 16 ページ。 Mining cable splice kit
3M Litmann Quality 3100 にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

3.4

If cable includes a ground check, the ground check connector should be

wrapped with one half-lapped layer of 3M

1700P extending ¼" (6 mm) onto existing insulation, followed by a half-lapped

layer (tacky side DOWN) of Scotch

extending ¼" (6 mm) past the 1700P tape, then using the same ¼" (6 mm)

overlap, add a final layer of half-lapped 1700P tape.

3.5

Connect remaining ground wires.

4.0

Replace Jacket

4.1

Start 1" (25 mm) above split or top of taper and apply half-lapped layers of

130C tape (tacky side DOWN) across splice and 1" (25 mm) past end of

opposite split or top of taper. Apply half-lapped layers, filling all voids until

splice area is returned to greater than or equal to original cable profile.

4.2

Start 2" (50 mm) from 130C tape and apply one half-lapped layer of Scotch

Heavy Duty Mining Tape 31 with mastic side toward the cable across the splice

and continue 2" (50 mm) past the end of the Scotch

Tape 130C. Always wrap the 31 tape toward the machine end of the cable.

Start taping here

2" (50 mm)

past end of

previous layer

78-8127-6830-3-C

1" (25 mm)

past split or

top of taper

Scotch

(Mastic side toward cable)

Temflex

™

Linerless Rubber Splicing Tape 130C

Figure 8

Scotch

Linerless

Rubber Splicing Tape 130C

Tacky Side DOWN

Figure 9

Machine End

Heavy Duty Mining Tape 31

Figure 10

Electrical Vinyl Tape

™