- ページ 9

録音機器 DAN NTP TECHNOLOGY DAD THUNDER CORE AX CenterのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center 19 ページ。 Thunderbolt 3, dante, madi and adat modular analogue & digital audio interface

ページを印刷する

Installation Guide AX Center

Installation of DAD Thunderbolt 3 driver for MacOS

The driver software has to be installed completely before it can work properly.

When you install the driver, it is of no importance whether you have units or other peripherical

devices connected to the Thunderbolt 3 / USB-C port on the computer. In the process described

below there are no devices connected before installation.

The installation sequence:

1. Copy the driver .pkg file to the computer desktop and double click to start the installation.

2. Follow the installation instructions. Click Next and then Install.

3. Enter Administrator password and click Install.

4. If the driver has not been installed before on the computer, you get the message "System extension

blocked". Click on Open Security Preferences.

5. In the "Security and Privacy" window you have to click on the lock symbol in the bottom left corner and

unlock settings and click Allow.

6. Restart the Computer and open the Thunderbolt 3 driver application and connect the DAD

Thunder|Core interface to the USB-C/Thunderbolt 3 port on the Computer. Make sure that you are

using a high-speed (20Gbps) Thunderbolt 3 USB-C cable.

For mor information how to install and configure the Thunderbolt 3 driver please refer to the Thunder|Core

installation guide on www.digitalaudiosupport.com.

Once the driver is installed the device can be attached to via the setup window.

Doc no. AXCNTR-8001-A-4

Figure 4, DADDriver setup window for MacOS

Rev. date 221023

Page 9 of 19