- ページ 8

3Dプリンター AnyCubic KobraのPDF マニュアルをオンラインで閲覧またはダウンロードできます。AnyCubic Kobra 10 ページ。
AnyCubic Kobra にも：ユーザーマニュアル (13 ページ)

Reconnect the cables.

On the underside, unscrew the cover above the mainboard. (2 screws.

Unscrew the cable holders and remove the old cable.

Then install the two new cables in the same way as the old one.

Reattach the cable holders and plug in the connectors on the mainboard, extruder and

printhead.

Replace the bottom with the two screws.

Fix the cables but be careful not to restrict the movement of the cables.

Screw the printhead back on with 3 screws.

(The screw at the top left will be inserted

later!)

Screw the cover back on.

Page 7 of 9