AnyCubic Kobra 매뉴얼 - 페이지 8

{카테고리_이름} AnyCubic Kobra에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyCubic Kobra 10 페이지.
AnyCubic Kobra에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지)

Reconnect the cables.

On the underside, unscrew the cover above the mainboard. (2 screws.

Unscrew the cable holders and remove the old cable.

Then install the two new cables in the same way as the old one.

Reattach the cable holders and plug in the connectors on the mainboard, extruder and

printhead.

Replace the bottom with the two screws.

Fix the cables but be careful not to restrict the movement of the cables.

Screw the printhead back on with 3 screws.

(The screw at the top left will be inserted

later!)

Screw the cover back on.

Page 7 of 9