- ページ 8

照明器具 Aolait AL350RXのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aolait AL350RX 17 ページ。

AC power

Warning! Read "Safety Information" starting on page 5 before connecting this light to AC
mains power.
Warning! For protection from electric shock, this light must be grounded (earthed). The
power distribution circuit must be equipped with a fuse or circuit breaker and ground-
fault (earth-fault) protection.
Warning! Socket outlets or external power switches used to supply this light with power
must be located near the fixture and easily accessible so that the fixtures can easily be
disconnected from power.
Important! Do not insert or remove live Neutrik PowerCon connectors to apply or cut
power, as this may cause arcing at the terminals and damage the connectors.
Important! Do not use an external dimming system to supply power to the 350BSW as this
may cause damage to the fixture that is not covered by the product warranty.
Power voltage
Warning! Check that the voltage range specified on the fixture's serial number label matches the
local AC mains power voltage before applying power to the fixture.
This light fixtures accept AC mains power at 100-240 V nominal, 50/60 Hz. Do not apply AC
mains power to the fixture at any other voltage than that specified on the fixture's serial number
label.

Data link

A DMX 512 data link is required in order to control a 350BSW via DMX.
This light has 5-pin XLR connectors for DMX data input and output. The pin-out on all
connectors is pin 1 = shield, pin 2 = cold (-), and pin 3 = hot (+). Pins 4 and 5 in the 5-pin XLR
connectors are not used in this light but are available for possible additional data signals as
required by the DMX512-A standard.
Standard pin-out is pin 4 = data 2 cold (-) and pin 5 = data 2 hot (+).
The number of fixtures is either limited to 256 or limited by the number of DMX channels required by
the fixtures in relation to the maximum 512 channels available in one DMX universe, whichever limit is
lower. Note that if independent control of a fixture is required, it must have its own DMX channels.
Fixtures that are required to behave identically can share the same DMX channels.
To add more fixtures or groups
8