- ページ 3

コントローラー Datapath Fx4のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Datapath Fx4 6 ページ。 Multi display controller
Datapath Fx4 にも：クイック・スタート・マニュアル (17 ページ)

COPYRIGHT STATEMENT

Datapath Limited claims copyright on this documentation. No part of this

documentation may be reproduced, released, disclosed, stored in any electronic

format, or used in whole or in part for any purpose other than stated herein without

the express permission of Datapath Limited.

Whilst every effort is made to ensure that the information contained in this Quick

Start Guide is correct, Datapath Limited make no representations or warranties with

respect to the contents thereof, and do not accept liability for any errors or omissions.

Datapath reserves the right to change specification without prior notice and cannot

assume responsibility for the use made of the information supplied. All registered

trademarks used within this documentation are acknowledged by Datapath Limited.

Page 10

STEP 2 CONNECT THE INPUTS

HDMI

Connect your input source to one of the 3 input connectors on the rear of the Fx4. You

can connect up to 3 input sources, 2 x HDMI and 1 x DisplayPort.

Ensure cables are inserted correctly, it is recommended that locking cable connectors

are used.

DisplayPort

Out Loop

Connect the monitor cables to the monitor output connectors on the rear of the Fx4,

you can connect up to 4 monitors to a single Fx4 unit. Ensure the cables are inserted

correctly, it is recommended that locking connectors are used.

The DisplayPort Out Loop is used to when connecting multiple Fx4 units.

Page 3

DisplayPort

HDMI or DisplayPort

Output Connectors