- ページ 11

エアーコンプレッサー Aircraft AIRBOY 206 OF EのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aircraft AIRBOY 206 OF E 18 ページ。 Mobile compressor

ページを印刷する

7.2 Switch on

Step 1:

Check whether the mains voltage corre-

sponds to the voltage indicated on the name-

plate. Connect the compressor to the power

supply.

Step 2:

Start the device with the On-/Off-Switch. The

compressor remains in operation until the com-

pressed air tank is filled. As soon as the maxi-

mum pressure (8 bar) is reached, the com-

pressor stops automatically. The pressure

value of the air in the tank is displayed on the

manometer. It is normal for the compressor to

stop and restart at certain intervals during use

of the compressed air.

7.3 Adjustment of working pressure

ATTENTION!

The maximum pressure of the connected tool must

not be exceeded.

The working pressure setting must be done with the tool

connected and running in order to be able to set the ac-

tual required working pressure.

When using pneumatic tools, always check the optimum

application pressure of the accessory.

The working pressure is with the pressure regulator (2,

Fig. 3) adjusted and read on the manometer. The com-

pressed air removal takes place via the coupling(8).

It is recommended to bring the pressure back to zero af-

ter using the device by continuing to operate the

connected tool until the pressure has released.

7.4 Switch off

Step 1:

To zero the pressure after using the device,

continue to operate the connected tool until

the pressure has released.

Step 2:

Turn off the compressor with the ON / OFF

switch and disconnect the power plug from

the socket.

Use safety gloves!

Step 2:

Place a container under the condensate drain

valve. Open the condensate drain valve to

drain the pressure vessel.

AIRBOY | Version 1.07

Maintenance, care and servicing/ repair

ATTENTION!

If the condensation is not drained, the tank can cor-

rode. This limits its capacity and compromises

safety.

condensate drain valve.

Fig. 5:

Step 3: Close the condensate drain valve.

Maintenance, care and servicing/

repair

8.1 Cleaning

ATTENTION!

- Never use solvents to clean plastic parts or painted

surfaces. A surface release and consequential da-

mage may occur.

Use safety gloves!

NOTE!

Never use harsh detergents for cleaning.This can

lead to damage or destruction of the device .

Step 1: Before performing any cleaning work, switch off

the compressor, disconnect the power plug,

and drain all air from the reservoir.

Step 2: Clean all plastic parts and painted surfaces

with a soft, damp cloth and some neutral deter-

gent.

Always keep the cooling fins clean and free.