セキュリティシステム ADEMCO Ademco VISTA-20PのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。ADEMCO Ademco VISTA-20P 6 ページ。 Programming auto arming and disarming schedules
ADEMCO Ademco VISTA-20P にも：クイック・インストール・マニュアル (2 ページ), プログラミング・マニュアル (17 ページ), ユーザーマニュアル (20 ページ), プログラミング・マニュアル (17 ページ), クイック・インストール・マニュアル (2 ページ), クイック・インストール・マニュアル (2 ページ), プログラミング・マニュアル (2 ページ), クイックマニュアル (2 ページ)

NOTE: DO NOT hook power to the keypad until the entire system is installed and

ready for programming. Reason: You have to make a programming change to

each keypad upon 30 seconds of power being sent to the keypad.

Upon 50 seconds of power up, you will need to press and hold * and # at

Exit Programming=*99 or 00 depending on where you are at

Step 1: Assign Keypad Address

 Within 30 seconds of the main keypad receiving power: Press and hold

the 1 and 3 buttons at the same time.

 Con Addr = will appear and you will need to enter 16. Then press *

 On each additional keypad you will need to enter a unique address: 17,

18, etc.

o Do Not Duplicate Keypad Addresses. Keypads have to be

addressed 16 to 23 (no duplicates), but come defaulted at 31 and

will not work until they are re-addressed.

Step 2: Enter Programming

After the keypad is addressed, you will need to enter programming:

 Enter 4112 800

 Field 20 (Installer Code) will be displayed on the screen.

 We can begin programming from this point.

Step 3: Default the Entire System (*97)

 Enter *97 to default your system. The system will beep. This will ensure

that there is a clean slate to start from.

 If you will be using central station monitoring: Press *96 and the system

will beep. This is for clearing the ID number for Central Station.

Step 4: Installer Code (*20)

 If you would like to change the installer code, press *20 + new installer

code. Be sure not to forget this number.

Quick Start Guide

Vista-20P

Installer Code = 4112

Master Code=1234

Program Mode= 4112+800

same time.

*=Change Data

#=View Data