ADEMCO Ademco VISTA-20P Manual de inicio rápido

Navegue en línea o descargue pdf Manual de inicio rápido para Sistema de seguridad ADEMCO Ademco VISTA-20P. ADEMCO Ademco VISTA-20P 6 páginas. Programming auto arming and disarming schedules
También para ADEMCO Ademco VISTA-20P: Manual de instalación rápida (2 páginas), Manual de programación (17 páginas), Manual del usuario (20 páginas), Manual de programación (17 páginas), Manual de instalación rápida (2 páginas), Manual de instalación rápida (2 páginas), Manual de programación (2 páginas), Manual rápido (2 páginas)

NOTE: DO NOT hook power to the keypad until the entire system is installed and

ready for programming. Reason: You have to make a programming change to

each keypad upon 30 seconds of power being sent to the keypad.

Upon 50 seconds of power up, you will need to press and hold * and # at

Exit Programming=*99 or 00 depending on where you are at

Step 1: Assign Keypad Address

 Within 30 seconds of the main keypad receiving power: Press and hold

the 1 and 3 buttons at the same time.

 Con Addr = will appear and you will need to enter 16. Then press *

 On each additional keypad you will need to enter a unique address: 17,

18, etc.

o Do Not Duplicate Keypad Addresses. Keypads have to be

addressed 16 to 23 (no duplicates), but come defaulted at 31 and

will not work until they are re-addressed.

Step 2: Enter Programming

After the keypad is addressed, you will need to enter programming:

 Enter 4112 800

 Field 20 (Installer Code) will be displayed on the screen.

 We can begin programming from this point.

Step 3: Default the Entire System (*97)

 Enter *97 to default your system. The system will beep. This will ensure

that there is a clean slate to start from.

 If you will be using central station monitoring: Press *96 and the system

will beep. This is for clearing the ID number for Central Station.

Step 4: Installer Code (*20)

 If you would like to change the installer code, press *20 + new installer

code. Be sure not to forget this number.

Quick Start Guide

Vista-20P

Installer Code = 4112

Master Code=1234

Program Mode= 4112+800

same time.

*=Change Data

#=View Data