- ページ 10

DVR DynaColor 960H H.264 DVRのPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。DynaColor 960H H.264 DVR 12 ページ。

Connect the DVR via the Remote Software
Setup Requirements:
 Make sure the PC is connected to the Internet.
 Obtain the IP address of the 960H H.264 DVR. To check the IP address of the DVR, click on
MENU and select <System>  <Network Setup>  <LAN Setup>  <IP> to check the IP.
Changing Internet Setting:
The 960H H.264 DVR only supports 32-bit IE browser. However, the DVR does not support IE
browser under WinMetro mode.
 Start the IE; select <Tools> from the main menu of the browser, then <Internet Options> and
then click the <Security> tab.
 Select <Trusted Sites> and click <Sites> to specify its security setting.
 Uncheck "Require server verification (https:) for all sites in this zone". Type the IP address of the
unit in field and click <Add> to add this website to the zone.
 In the Security Level area, click <Custom Level>. Under <ActiveX controls and plug-ins>, set
all items to <Enable> or <Prompt>.
 Click <OK> to accept the settings and close the <Security Settings> screen.
Using the Remote Software:
 Start the IE and enter the IP address of the 960H H.264 DVR in the address bar.
 The ActiveX controls and plug-ins dialog will show up twice for confirmation; click <YES> to
accept ActiveX plug-ins. The DVRRemote plug-ins will be downloaded and installed on the PC
automatically when the connection is successfully made.
NOTE: Do not enter any leading "0" characters in the address, for example,
"192.068.080.006" should be entered as "192.68.80.6".
NOTE: If the default trigger port 80 is changed to another port, e.g. port 81, the IP
address should be entered as "192.68.80.6:81".
 Version verification starts automatically to verify whether DVRRemote was installed. This
process may take up to 30 seconds.
 When the software is completely downloaded and installed, the Login Window is displayed.
 Enter username and password. The default username and password is admin and 1234.
10