- ページ 12

おもちゃ GREAT PLANES PBY CatalinaのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES PBY Catalina 20 ページ。 Arf

location of the mounting holes and then drill a 1/16" [1.6mm]

hole through each of the marks and through the elevator.

Secure the control horn to the aileron with two 2 x10mm

[3/8"] screws and the nylon control horn plate.

❏

5. Install a servo into the other servo opening in the

servo tray. Remove three of the four arms from the servo

horn leaving the longest arm in place. Enlarge the last hole

in the servo arm with a #57 drill. Install an aluminum screw

lock connector into the hole and lock it in place with a nylon

retainer. Install a set screw into the screw lock connector.

Install the servo into the opening on the right side of the

fuselage using the hardware that came with the servo. Center

the servo and install the servo arm as shown.

❏

6 Install the remaining .95 x 360mm [14"] long pushrod

wires into the right side of the fuselage, sliding it into the servo

compartment. Slide the wire into the hole in the screw lock

connector and lightly tighten the set screw against the wire.

❏

7. Install a screw lock connector into the outer hole of a

control horn. Slide the screw lock connector onto the pushrod

wire. Examine this picture, taking note of the hinge line of the

rudder. Then position the control horn so the outer mounting

hole is in line with the hinge line. Mark the location of the

mounting hole. Then drill a 1/16" [1.6mm] hole through each

of the marks and through the rudder. Secure the control horn

to the aileron with two 2 x 25mm [1"] screws and the nylon

control horn plate.

Install the Speed Control,

Receiver and Batteries

❏

1. From the adhesive hook and loop material provided

with the kit, cut a piece large enough to ﬁ t the back of your

receiver. Adhere one side of the hook and loop to the receiver

and the other side to the plywood receiver mounting tray

located inside the fuselage in the wing pod.

❏

2. Cut the 24" [610mm] plastic antenna tube to a length of

18" [457mm]. Insert the receiver antenna into the tube.

❏

3. Install the receiver onto the hook and loop material you

installed and place the antenna tube along the side of the fuselage,

securing it with a couple of drops of glue to the fuselage.