- ページ 4

GPS Automotive ET3334のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Automotive ET3334 4 ページ。 Circuit tracer

Automotive Circuit Tracer

4.11 Tracing multiple loads:

When tracing a wire with multiple loads (refer Fig. E), it is better to disconnect all the other

unneeded loads. This is because the signal from the transmitter will flow along the whole

circuit and there may be too many loads, based on the circuit layout and loading circuit, this may

reducethe the signal strength and make it harder for the receiver to pick up the signal. The less

being traced, the easier it will be to get an accurate result.

4.12 When to change the battery:

Both red and green LEDs will flash and then power off automatically if the battery is low.

5. MAINTENANCE:

WARING! DO NOT attempt to repair or service this tool unless you are qualified to do

so. To avoid damage do not get water inside the case.

1. Periodically wipe the case with a damp cloth and mild detergent. Do not use solvents.

2. Turn the sender and receiver units off when not in use and remove the batteries if stored

for an extended period of time.

3. Do not store in a place of high humidity or high temperature.

4. To replace the batteries on either the sender or the receiver units, simply open the rear

battery cover and replace with a 9V battery.

Fig. E

-04-

2202AC