- ページ 4

産業機器 DBI SALA Anchor on the GoのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。DBI SALA Anchor on the Go 20 ページ。 Portable roof anchor for metal roofs

1.1 Anchor Design and Application

The Anchor on the Go™ Portable Roof Anchor for Metal Roofs has been

designed and tested to 15kN and is therefore rated as a single person fall

arrest anchor under AS/NZS1891.4. It is only suitable for use on roofs

constructed with metal roof sheeting with a minimum BMT of 0.42mm

in the following profiles – Custom Orb, Trimdek, Spandek and Klip-Lok

406 & Klip-Lok 700 provided ridge-capping is secured in place with roof

screws per manufacturer's instructions.

IMPORTANT: The Anchor on the Go™ Portable Roof Anchor is NOT

suitable for tiled, shingled, aluminium sheet, asbestos or decramastic

roofs.

IMPORTANT: This anchor is designed to be attached to the opposite

side of the roof from where you intend to work. Do NOT connect to or use

the anchor on the same side of the roof where the anchor is connected.

If a second person is required to work on the roof, a second anchor

device must be used. Connecting two lines to a single anchorage device is

NOT permitted. Where two connecting devices are attached to the same

anchorage point (e.g. two snap hooks), the snap hooks may rub against

each other, causing them to be entangled or even become disengaged

from the anchorage device.

Additionally, testing has concluded that whilst this device can sustain a

load of 22kN, the roof sheeting profiles most commonly used in Australia

and New Zealand will not sustain a static load greater than 15kN.

IMPORTANT: Do NOT work outside an arc of 30 degrees either side of

the centre line of the anchorage location to reduce the danger of swing

fall hazards - refer to Figure One over the page.

The user

of this

Anchor on the Go™ Portable Roof Anchor shall be

trained and ensure that care is taken to adjust the safety line length so

that he/she will not be able to fall off the ends of the roof.

IMPORTANT: Anchor on the Go™ Portable Roof Anchor is NOT suitable

for use as an anchorage device for a Temporary Horizontal Life Line.