- ページ 12

リフティングシステム AGT INDUSTRIAL AGT-B1000のPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。AGT INDUSTRIAL AGT-B1000 19 ページ。 Two-post auto lift

when it is raised to a certain height ( stop and check).

* Danger* : Unlocked arms can cause vehicle fall off from the lift.

4.3 Stopping

After raising to desired height, press the lower lever and the lift will automatically lower to a

safe position, the safety lock will be engaged and the lift will be locked.

The safety lock must be released before lowering.

1. Press the power switch to raise the car by approximately 30mm/1.2" .

2. Pull the safety lock release cables on both sides to unlock.

3. Press the lower lever to start lowering process, the arm lock will be automatically

released and allow the arm rotating when the vehicle is completely lowered to the ground.

Please read this manual carefully as it contains important safety information that the

operators need to know.

* WARNING* : The design and construction of this lift is only suitable for lifting whole

vehicle. All other uses are unauthorized, this lift CAN NOT be used to: wash vehicles,

build lifting platforms, lifting personnel, use as cargo lifts and use as lifting partial of

the vehicles.

1 . During vehicle lifting process, operators should be at a safe position/ area.

2 . Turn off the vehicle engine and manual brake on.

3. Load vehicle correctly (Fig 13).

4 . The vehicle CAN NOT exceed the rated lifting capacity and required size.

Once the vehicle is raised, vehicle CAN NOT be moved backwards or forwards as it may

cause falling.

* WARNING* : Do not attempt to move the vehicle while it is parked on the lift.

Fig 13 correct way to load vehicle

Page 12 of 19