- ページ 9

配管製品 Bristan Pisa seriesのPDF 取付説明書＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bristan Pisa series 12 ページ。

5. Installation Bath Shower Mixer

Identify all components are present prior to installation.

Install the mixer body to the bath using the backnuts (11) and washers (10) provided under

the bath with washers (9) and the plinth (8) above.

Fit the hose to the mixer, underneath the centre of the tap to hose outlet.

Fix the wall bracket (13) to the wall ensuring that the handset (15) and hose (14) will reach

it.

Connect the hot and cold water supplies and turn water supplies on.

Fully open the valves by turning handles, letting it run for a few minutes to check for leaks.

Operate the mixer in both bath and shower mode. To switch from bath to shower mode, pull

the diverter knob up. To revert back to bath fill mode push the diverter down.

1. Cap

2. Grub Screw

3. Handle

4. Spline Adaptor

5. Valves

6. Body

7. Inlet Connections

8. Plinth

9. Washer

10. Washer

11. Backnut

12. Diverter Knob

13. Wall Bracket

14. Hose

15. Handset

16. Flow Straightener

(x2)

(x1)

(x2)

(x1)