- ページ 7

浄水器 Adey MagnaCleanseのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Adey MagnaCleanse 12 ページ。
Adey MagnaCleanse にも：ユーザーマニュアル (8 ページ)

Step-by-step

Continue the VibraClean radiator

agitation to dislodge any sludge

deposits until the return hose to the

RapidFlush filter runs clear.

Isolate and clean the RapidFlush filter

as required. Using Personal Protective

Equipment i.e. gloves and paper towels,

wipe off any magnetite into a bucket.

Waste should be bagged and thrown

away. When satisfied, open up the

next radiator, turn off the treated

radiator and repeat the process until all

radiators are clean.

Sludge removal tool available at

adeyspares.co.uk.

You will need flexible hoses with isolators.

Remember to double check valve, pressure

reducing valve and gauge. Isolate electrics to

the boiler and set the boiler control to OFF.

Attach a drain hose to the MagnaCleanse

drain valve and secure with a jubilee clip. When

cold, temporarily cap off the expansion pipe.

Temporarily connect the cold mains supply and

tank cold feed supply (to bypass header tank)

including a combined stop tap and pressure

gauge to control the water pressure.

Bypass expansion heating tank as shown

opposite (fittings not supplied). This is a

temporary basis for the cold flush of the

flushing process ONLY. The blank vent

pipe is a temporary measure during cold

flush ONLY. Never blank vent pipes for any

other reason. HEATING BOILER MUST

BE OFF and ISOLATED FOR THE COLD

FLUSH. Set pressure reducing valve to

under 1 bar pressure before commencing

cold flush. Caution: Do not over pressurize

existing heating system during cold flush.

Remember to double check valve, pressure

reducing valve and gauge.

Cold main

Cold feed

Remember to monitor the

MagnaCleanse system

throughout operation.